![]() Ruijie(config)#webmaster level 0 username ruijie password ruijie Web auth privilege level (0 is the highest level) To display SSH service status, execute following commands Open Putty, choose Connection type "SSH", input IP address. Ruijie(config)#username admin password ruijie Method 2 : Login with username & password Choosing a key modulus greater than 512 may take Windows7&8 telent client function is not enabled by default, you need to enable the telnet functionality.Ĭontrol panel - procedures and functions - to open or close the windows function - check the telnet client - select "to determine"Ĭhoose the size of the key modulus in the range of 360 to 2048 for your Note: when ap-mode change from fit to fat, the default password changes as follow: Ruijie(config-if-GigabitEthernet 0/1)#exit Ruijie(config-if-GigabitEthernet 0/1)#encapsulation dot1Q 1 Ruijie(config-if-bvi 1)#interface gigabitEthernet 0/1 Ruijie(config)#ip route 0.0.0.0 0.0.0.0 192.168.1.2Ĭonfiguring Telnet & Enable password on APĬonsole connect to device and set passwords, default ap-mode is fit. Open software Putty, set baud rate to 9600Ĭonfiguring Telnet& enable password on AC In Fit mode, IP address of both LAN port and Uplink port IP are 192.168.110.1/24 AP : Default IP address is 192.168.110.1(or 192.168.1.1), and both console & telnet password are "admin", default enable password is "apdebug"įollowing wall AP have different default settings
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |